Aluminium sheet, Rheola Works, Glynneath, 1981
Description
Inside Rheola Works aluminium factory. Workers on factory floor with finished aluminium sheet.
External source:
This item also appears in
Contact Us
To request take down or report racist, offensive or otherwise harmful content.
Comments (1)
Submitted by Martyn Leonard… on Fri, 19/01/2024 - 11:23
This picture shows the Brightside Reversing Hot Breakdown Mill at 80" width that could roll DC cast slabs of 14" thickness down to 1/2" to 1" thick. The hot mill blank would then pass down the hot mill table ( behind the mill stand in this picture) to a 3 stand warm tandem mill which was capable of taking the blank down to 3-8mm thick coil for subsequent cold rolling or cutting up as plate/shate.
You must be logged in to leave a comment