Content can be downloaded for non-commercial purposes, such as for personal use or in educational resources.
For commercial purposes please contact the copyright holder directly.
Read more about the The Creative Archive Licence.

Description

Men at work in the motor room of Aluminium Corporation Limited, Dolgarrog

Do you have information to add to this item? Please leave a comment

Comments (1)

Martyn Leonard Alderman's profile picture
In 1959 Aluminium Corporation installed a 800HP Robertson 60" wide 2Hi-reversing hot mill to break down 650lb slabs into sheet & coil. This replaced the 3 Hi Krupp Mill previously used as the hot mill. In this photograph it appears that the main reduction gearbox has not yet been installed but the AC driven MG(motor-generator) set is in place to generate the DC required to feed the mill. The AC generator set had a large flywheel to accumulate power that was drawn down when the mill was in full operation. If the mill operator tried to draw too much power with multiple large reductions the MG set would slow down and ring an alarm bell to warn the hot mill operator he was a risk of stalling the mill.

You must be logged in to leave a comment